1. Attach the right and left side of the float guides.
NOTE:
Make sure that they have their own direction, the float
guide with a circle should be left and the guide with an
ellipse should be right.
2. Solder the lead wires with the module.
NOTE:
The red lead wire should connect with "MT1" on the
module and the white lead wire should connect with
"MT2".
Make sure that the lead wires do not set on or over the
components on the module.
3. Install (+) terminal of battery into the terminal at the linear
motor side and firmly set the battery sliding the direction of
arrow. Attach (-) terminal of battery.
4. When inserting the battery and module assembly into the
housing A, confirm if the modules or coil do not get any
damage or deformation.
5. Attach the battery waterproof rubber to the battery pins and
the housing bosses with care of its direction and no foreign
substance sticking around.
6. Set the linear motor assembly on the housing A and sliding
it upward to hook. Confirm that the lead wire tube fits to the
housing A firmly and no foreign substance sticking around.
4 CAUTION IN ASSEMBLY
NOTE: When reassembling, replace the new waterproof rubber.
Make sure whether there is NO foreign substance sticking around a part covered with waterproof seal.
5
ES8093-A3
