National 5200 PANTHER, Инструкция по эксплуатации

Страница: 13 / 100

Page 12
5200 & 5200QL BATTERY OPERATION
After plugs are free, hold power pack by handles. Lift battery clear of machine. Set down on the floor or
charging cart.
Note: When lifting power pack out of machine, power pack can be momentarily rested on the sidewall of
machine before lowering to the floor or cart (figure A). For two person removal of power pack, follow
same procedure as above, using one person on each side. Facing each other (for good communication),
each person holds on to a handle (figure B). Set the power pack down on the floor or charging cart.
REPLACING POWER PACKS - 5200
Reverse procedure from above. Set power pack straight into machine, not at an angle. Make sure power
pack is nested properly into machine, between rubber bumpers and front and back stops.
Note: There is a right and left to each power pack as well as a front and back.
From a seated position, the power pack with a blue plug is the right hand pack. Blue plug to the front, red
plug to the rear. Power pack with no plug in the front is the left pack. No plug to front, red plug to rear.
Failure to properly install power packs correctly will not allow power hook up. Once power packs are
properly installed, connect gray plug at top, blue plug at front. Failure to connect all the plugs will not
allow machine to operate. Make sure plugs are connected firmly and securely together. Plug connectors
are stiff. Close hood. Machine is now ready to operate.
WARNING: Remove battery charger’s from machine before operating. Failure to do so could
cause damage to machine or bodily injury.
WARNING: Failure to do so could cause damage to plug connection resulting in possible electrical
shock.
CAUTION: Hood has pinch points. Do not get hands or fingers pinched when closing hood.
WARNING: Disconnect battery charger from machine before servicing machine.
BATTERIES (continued)
REMOVING POWER PACKS - 5200
Each pack weighs 140 pounds (63.50 kilos). For safe removal, additional help may be needed. Open and
secure hood. Remove all three plug connections (red, blue and gray). Never try to lift packs out of
machine before completely disconnecting the blue plug in front and the gray plug on top.
Figure A Figure B