NI 1357/1358/1359 Kit Installation Guide
10
ni.com
c.
Select the
Channels
tab.
d.
Designate source channels for the topology selected in the
Terminal Block/Topology
tab. Notice that you can set different
source channels for each topology.
e.
Designate reserved channels for routing. Notice that you can
reserve different channels for routing in each topology.
f.
Click
OK
to accept the changes.
8.
To configure additional SCXI switch modules, repeat steps 6 and 7.
9.
If necessary, select the
Chassis
tab to modify chassis settings.
10. Click
OK
to accept and save the settings for the chassis.
Note
You cannot save the chassis configuration until after you enter the switch module
information. A message at the top of the SCXI Chassis Configuration dialog box displays
the configuration status. If a warning appears in the message box, you can save the
configuration. If an error appears in the message box, you cannot save the configuration.
11. To test the configuration, right-click the chassis name listed under
Devices and Interfaces
, and select
Test
.
After the test, a message indicates successful verification of the
configuration or if an error occurred. If an error occurs, refer to
ni.com/support/install
for troubleshooting information.
Specifications
Maximum Voltage
Terminal to earth ....................................300 V
rms
or VDC
Terminal to terminal ...............................300 V
rms
or VDC
Maximum Current
Maximum current (per channel) .............2 ADC, 2 AAC
Bus Interface
USB specification ...................................USB 2.0 full-speed
USB bus speed........................................12 Mb/s
USB Power Requirements
5 VDC.....................................................25 mA typical, 100 mA max
Содержание SCXI USB-1357
Страница 1: ...USB 1357...
