![background image](http://html2.mh-extra.com/html/national-instruments/ni-scb-68a/ni-scb-68a_user-manual_3405895062.webp)
3-2
|
ni.com
Chapter 3
Analog Output Waveforms
Figure 3-2 illustrates the generic AO channel pad configuration.
Figure 3-2.
Analog Output Channel Pad Configuration
Table 3-1 correlates the component labels of the SCB-68A to component locations A and B for
analog output channels 0 and 1.
Lowpass Filtering
Lowpass filters highly or completely attenuate signals with frequencies above the cut-off
frequency, or high-frequency stopband signals. Lowpass filters do not attenuate signals with
frequencies below the cut-off frequency, or low-frequency passband signals. Ideally, lowpass
Table 3-1.
Analog Output Channels Component Locations
Channel
Positions A
*
and B
†
AO 0
SC8
AO 1
SC9
* A position contains a surface mount 0
Ω
resistor; you
must
remove the resistor to use the position.
If you remove your custom components from the A position, you
must
reinstall a 0
Ω
resistor.
†
B position contains through hole pads that can be used for two components to be connected in parallel.
56
22
55
21
54
20
S
C
8
S
C9
A
A
B
B
+
+
AO 0
AO 1
AO GND
AO GND