2-2
|
ni.com
Chapter 2
Installation and Configuration
4.
Remove the protective plastic covers from the four bracket-retaining screws as shown in
Figure 2-1.
Figure 2-1.
Removing Protective Screw Caps
5.
Make sure the injector/ejector handle is in its downward position. Align the NI PXIe-8880
with the card guides on the top and bottom of the system controller slot.
Caution
Do
not
raise the injector/ejector handle as you insert the NI PXIe-8880.
The module will not insert properly unless the handle is in its downward position
so that it does not interfere with the injector rail on the chassis.
6.
Hold the handle as you slowly slide the module into the chassis until the handle catches on
the injector/ejector rail.
7.
Raise the injector/ejector handle until the module firmly seats into the backplane receptacle
connectors. The front panel of the NI PXIe-8880 should be even with the front panel of the
chassis.
8.
Tighten the four bracket-retaining screws on the top and bottom of the front panel to secure
the NI PXIe-8880 to the chassis.
1
Protective Screw Cap (4x)
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
