National Instruments NI 6581, Руководство по началу работы

Страница: 17 / 23

Installing the NI FlexRIO Adapter Module
Note
Skip this step if you are not using an adapter module.
1. Gently insert the guide pins and the high-density card edge of the NI FlexRIO adapter
module into the corresponding connectors of the NI FlexRIO FPGA module, as shown in
the figure below.
Figure 12. Installing the NI FlexRIO Adapter Module
PXI-1000B
1
4
3
2
5
1. NI FlexRIO Adapter Module
2. Captive Screw
3. Guide Pin 4. PXI/PXI Express Chassis
5. NI FlexRIO FPGA Module
The connection may be tight, but do not force the adapter module into place.
2. Tighten the captive screws on the NI FlexRIO adapter module to secure it to the
NI FlexRIO FPGA module. NI recommends using the laser-tipped screwdriver (part
number 748677-01) included in the NI 6581/NI 6581B packaging.
3. Launch LabVIEW to begin configuring your NI FlexRIO system.
Note
MAX only recognizes FPGA modules that are in the chassis. Your
adapter module will not appear in MAX.
Installing PXI EMC Filler Panels
To ensure specified EMC performance, PXI EMC filler panels must be properly installed in
your NI FlexRIO system. The PXI EMC filler panels (National Instruments part number
778700-01) must be purchased separately.
16 | ni.com | NI 6581/6581B Getting Started Guide