![background image](http://html1.mh-extra.com/html/national-instruments/fieldpoint-fp-ctr-502/fieldpoint-fp-ctr-502_operating-instructions-manual_3386126015.webp)
FP-CTR-502 and cFP-CTR-502
14
ni.com
4. Set the Count Source of the prescaler counter to the clock on
which you want to base your pulse train. This can be the
external counter input or one of the [c]FP-CTR-502 internal
references.
5. Subtract 1 from the value that you want to divide the input
clock by, and set the terminal count of the prescaler counter to
the result. For example, a terminal count of 4 divides the input
clock by 5. If you use the 1 kHz reference as the prescaler count
source, this setting generates a 200 Hz clock for the pulse
counter.
To determine the frequency of the prescaler output, use the
following formula:
where
f
pre
is the frequency of the prescaler counter output
f
src
is the count-input frequency for the prescaler counter
term
pre
is the terminal count value for the prescaler
counter
Step 2. Set Up the Pulse Counter
To set up the pulse counter, complete the following steps:
1. Set the Count Source of the pulse counter (the count-input
channel with the higher number) to
Previous Channel
so that
it uses the output from the prescaler counter.
Note
If you are not using a prescaler counter, set the
Count Source to the clock on which you want to base
your pulse train.
2. Set the Read Reset Mode of the pulse counter to
Don’t Reset
On Read
and set the Gate Source to
Always Enabled
.
3. Subtract 1 from the value that you want to divide the count
input by and set the Terminal Count of the pulse counter to the
result.
The internal output from the pulse counter triggers the output
channel that you selected for the pulse train output.
f
pre
f
src
term
pre
1
+
----------------------------
=
Содержание FieldPoint FP-CTR-502
Страница 1: ...cFP CTR 502...