![background image](http://html1.mh-extra.com/html/national-instruments/cb-37f-lp/cb-37f-lp_installation-manual_3401866003.webp)
©
National Instruments Corporation
3
NI CB-37F-LP Installation Guide
Connections, including power signals to ground and vice versa, that exceed any of the
maximum signal ratings on the connector block can create a shock or fire hazard, or can
damage any or all of the boards connected to the host computer, and the connector block.
National Instruments is
not
liable for any damages or injuries resulting from incorrect
signal connections.
Clean the device and accessories by brushing off light dust with a soft non-metallic brush.
Remove other contaminants with a stiff non-metallic brush. The unit
must
be completely
dry and free from contaminants before returning it to service.
Connecting the Signals
Refer to the help file for the NI 37-pin device for a list of signals available
on the CB-37F-LP.
Refer to Figures 1 and 2 as you complete the following steps to connect
signals to the connector block.
Figure 1.
CB-37F-LP Parts Locator Diagram
1
Signal Wires
2
Screw Terminals
3
Connector Block Mounting Screw Holes
4
Rubber Feet
5
Connector
1
4
3
5
4
3
2