National Instruments CAN PXI-846 Series, Начало работы

Страница: 62 / 65

Index
PXI-846x and NI-CAN for Windows 98/95 Index-2 ni.com
E
error messages, F-1
Diagnostic Utility failures, F-5
Hardware Problem Encountered, F-6
interrupt resource conflict, F-5
memory resource conflict, F-5
Missing Board in Device Manager, F-2
Missing Board in Diagnostic Utility, F-5
NI-CAN Software Problem
Encountered, F-5
No National Instruments CAN
Interfaces, F-1
Problem Shown in Device Manager, F-3
H
hardware
installing, 2-2
overview, 1-2
uninstalling, A-1
Selecting an Interface to Remove
from Windows 98/95 (figure), A-2
high-speed CAN
bus power supply requirements
(table), C-4
cable lengths (table), C-5
cable specification (table), C-5
cable termination, C-6
cabling example (figure), C-7
cabling requirements, C-1
number of devices, C-6
port characteristics, G-2
power supply, C-2
power source jumpers (figure), C-4
termination resistor placement
(figure), C-6
I
installation, 2-1
Add/Remove Programs Properties dialog
box (figure), 2-1
of PXI hardware (figure), 2-3
of PXI-8460, PXI-8461 or PXI-8462, 2-2
verifying, 3-1
interrupt resource conflict, F-5
L
LabVIEW, 1-4, 4-2, F-7
LabWindows/CVI, 1-3
low-speed CAN
bus power supply requirements
(table), B-3
cable specification (table), B-4
cabling example (figure), B-8
cabling requirements, B-1
determining necessary termination
resistance, B-5
number of devices, B-4
port characteristics for bus-powered
ports, G-2
power supply, B-2
power source jumpers (figure), B-3
preparing lead wires of, (figure), B-7
replacing termination resistors, B-7
termination resistor placement
(figure), B-5
termination resistors, location of,
(figure), B-7
M
Measurement Studio, 1-3
memory resource conflict, F-5
Missing Board in Device Manager (error
message), F-2
Missing Board in Diagnostic Utility (error
message), F-5