National Instruments CA-1000, Руководство по установке

Страница: 3 / 21

CA-1000 2 ni.com
What You Need to Get Started
You need the following items to set up and use your CA-1000 enclosure:
❑
CA-1000 Configurable Connector Accessory Enclosure Installation
Guide
❑
CA-1000 enclosure
❑
CA-1000 hardware
– Panelette label sheet
– Rubber feet kit
• Four rubber feet
• Four 4-40 panhead shoulder screws with 0.08 in. shoulder
length and 0.125 in. thread length
– Filler panel and standoff kit
• Four black blank filler panels
• Two silver 68-pin filler panels
• Ten 4-40
×
3/16 in. black flathead screws
• Four 4-40
×
1/2 in. female to female nylon standoffs
❑
National Instruments supplied screwdriver
❑
Rack-mount kit (optional)
❑
Stack-mount kit (optional)
❑
One of the following internal accessories:
– SC-2040
– SC-2042-RTD
– SC-2043-SG
– SC-2070
– SC-2071
– SC-2072
– CB-50LP
Note The above internal accessories require an R50M-50F ribbon cable to make a 50-pin
external connection. They require a 68M-50F MIO Bulkhead Ribbon Cable to make a
68-pin external connection.
– CB-68LPR
– SCB-68