Index
©
National Instruments Corporation
I-3
G
gain and input ranges for thermocouples,
selecting, 3-5 to 3-6
ground-referenced signal sources
differential inputs, 4-7
single-ended inputs, 4-7
H
highpass filters
building, 4-10 to 4-12
highpass filter on differential channel 1
(figure), 4-12
normalized frequency response
(figure), 4-10
I
input modes, configuring, 4-5
installation
cable positioning (figure), 2-11
instructions, 2-10
power-on sequence, 2-11
unpacking the AMUX-64T, 1-2
I/O connector (J1, J2, and J42), 3-1 to 3-4
AMUX-64T signal routing (figure), 3-4
pin mapping for J1, J2, and J42 (table),
3-2 to 3-3
J
jumpers and switches. See configuration.
L
LabVIEW and LabWindows application
software, 1-3
linearizing thermocouple data, 3-6 to 3-9
lowpass filters
building, 4-8 to 4-9
lowpass filter on differential channel 1
(figure), 4-9
normalized frequency response (figure),
4-8 to 4-9
M
manual. See documentation.
MIO board power budget (table), 2-5
multiple-board configuration. See
configuration.
N
National Institute of Standards and
Technology (NIST) polynomial coefficients
for thermocouples (table), 3-8
NI-DAQ driver software, 1-3 to 1-5
nonreferenced or floating signal sources,
4-5 to 4-6
bias return resistor for DC-coupled
floating source (figure), 4-6
differential inputs, 4-5 to 4-6
single-ended inputs, 4-6
O
onboard temperature sensor. See temperature
sensor selection.
operation of AMUX-64T. See theory of
operation.
optional equipment, 1-7
P
parts locator diagram (figure), 2-2
physical specifications, A-3
pin mapping. See I/O connector (J1, J2, and
J42).
polynomial coefficients for thermocouples
(table), 3-8
power requirement specifications, A-3
