The trim feature helps align the drone during flight and counter any drift, i.e. if it “pulls” in one direction when the
controller is in the centered position. Each time you put in the battery the balance of the drone may be slightly
affected by the exact battery position. Therefore it might need to be adjusted by TRIMMING the drone. If your drone
drifts forward/backward without any control input, you can correct it by pressing the forward/backward TRIM buttons
in the direction you would like it to move to counter any drift. A beeping sound when adjusting TRIM will indicate the
maximum amount of adjustment in the chosen direction has been reached. You can TRIM the drone left/right using
the same process.
BATTERY INSTALLATION AND CHARGING
TRIM
FORWARD/
BACKWARD
TRIM
LEFT/
RIGHT TRIM
If the quadcopter keeps
rotating to the left/right, you
can correct it by pressing
either of the lower trim
buttons left/right.
If the quadcopter keeps flying
forward/backward, you can
correct it by pressing either
of the top trim buttons up or
down.
NOTE: Trim buttons are located on both sides of the remote control for easy access. Adjusting either
side will result in the desired change.
Once you are familiar with the operation of the drone, you can do some pretty amazing tricks and stunts. Start by
flying the drone to a height of more than 10 feet (3 meters). Simply press the FLIP button on the top right of the
remote control and then immediately push the DIRECTION lever in any direction to create a 360° flip in that direction.
TIP: Tricks take a lot of power from the battery. Make sure that you perform them before your battery power is low.
BATTERY INSTALLATION AND CHARGING
ONE-BUTTON 360 DEGREE FLIP
PRESS FLIP BUTTON
PUSH DIRECTION LEVER
=
+
FLIP
