Remove the battery cover on the back of the remote control and
install 4 x AA batteries (not included). Make sure to follow the
diagram on the inside of the battery compartment to ensure that
batteries are installed in the correct direction. Replace the battery
cover on the remote.
INSTALLING BATTERIES IN THE REMOTE
INSTALLING BATTERIES IN THE REMOTE
BATTERY
COVER
4X 1.5V AA BATTERIES
With remote control and drone powered OFF, turn the drone over
on a flat and stable surface. Connect the 3.7V 750mAh LiPo battery
(included) directly into the black connector piece located inside the
drone battery compartment.
Step 1
Insert the battery into the slot located directly inside the battery door
(battery slot is located at the top of the battery compartment when
the drone is upside down). The battery should slide in parallel to the
bottom of the drone and fit snugly inside this compartment.
VERY IMPORTANT: Insert the battery before inserting the cords.
Step 2
Place the connected wires into the battery space directly below the battery
slot. Close and secure the battery door.
NOTE: To facilitate easy removal of the battery, it’s very important to insert
the battery wires after you have already inserted the battery.
Step 3
BATTERY INSTALLATION AND CHARGING
BATTERY INSTALLATION AND CHARGING
