Page 19
REMOVING TOP GEAR PLATE
•Remove belt, following belt removal instructions (page 14-16)
•With a 4 millimeter allen wrench, remove the four gear plate cover screws (Figure A)
•Remove gear plate (Figure B)
•Remove both snap rings (Figure C)
•Remove gear (Figure D)
•Block up gear (Figure E)
•Knock out bearings (Figure F)
•Reinstall bearings one at a time
N
OTE
:
HITTING AROUND THE OUTSIDE PERIMETER OF THE BEARING
,
KEEP THE BEARING AS STRAIGHT AS POSSIBLE
•Replace gear back onto plate keeping fingers clear (Figure G)
(PINCH POINT), wiggle bearing until it drops down. D
O NOT FORCE
.
•Reinsert snap rings making sure they are seated in the groove
•Reinsert gear plate
•Reinsert four screws
•Reinstall belt
8274/9274 PROCEDURE
LIGHT IN CORD PLUG
Red flashing light in cord plug is normal (Figure H).
The red (LED) shows the pulses to the motor
Figure C
Figure D
Figure B
Figure A
Figure F
Figure G
Figure E
Figure H
