National Flooring Equipment PANTHER 5280, Инструкция по эксплуатации, Страница: 11 / 46

Page 10
5280 GENERAL OPERATION
MAINTENANCE
1. Always wear eye protection.
2. Keep flammable and fragile objects away from this tool.
3. Always check nuts and bolts to make sure they are tight.
4. Always use the tool with proper voltage specified in the machine’s name plate.
5. Always keep guards in place.
6. Do not operate around water or wet conditions without use of GFI on cord.
7. Use properly grounded cord and receptacle.
8. Unplug from power before servicing.
9. Use 12 gauge or heavier wire cord, not exceeding 50 feet in length.
10. Do not force machine.
11. Do not alter machine.
12. Pressure valve has been factory set and should NOT be tampered with.
13. Hydraulic Fluid: Keep clean and at a proper level.
14. Keep wheels free from debris.
INSPECTION PROCEDURE HYDRAULIC
PREVENTIVE MAINTENANCE CHECKLIST
By following this preventive maintenance checklist, you can maintain your equipment
hose efficiently, safely and with very little effort. Each step is covered in detail in the
following section.
Always turn off and unplug electrical source before servicing.
Place equipment and components in a safe or neutral position.
Remove access panels (if any) and inspect hose and fittings for damage or leaks.
Repair or replace as needed.
Inspect all hydraulic components.
Reinstall the access panels.
Turn power back on.
Be aware of your equipment, always look and listen for anything unusual.
WARNING: Do not lock wheel drive into a permanent on position. If operator would lose control or
be disabled, machine continues to operate.