Page 6
Natcomm
CALLER ID (CLI) USERS
Both Models
If you use Caller ID (CLI) on one or both of the attached telephone lines and your
attached ‘device’ provides a display of Caller ID, then you should note the following:
Caller ID can only be ‘read’ and displayed for incoming calls on Line 1.
CLI cannot be detected on Line 2 because Line 2 can only be connected to the
‘device’ after the detection of 1 full ring. For Line 2, this is a problem as CLI is
transmitted before the first full ring.
ADSL USERS
Both Models
If you use ADSL on one or both of the attached telephone lines, then you should note
the following :
Where ADSL is used on either telephone line connected to Line Selector, it is
Recommended to fit a SINGLE High Quality ADSL filter immediately ahead of Line
Selector. Failure to do so, or use of additional ADSL filters connected direct to your
telephones, can cause problems in the operation of Line Selector and your ADSL
service.
CALL ADVICE FACILITY
Model LS2 only
This facility will inject an ‘Advice Tone’ into an existing call, to alert you that there
is an incoming call on the other line. It is designed for use when one or more
telephones are connected to the DEVICE port of Model
LS2
.
By pressing the * button on your telephone device, it will allow you to place the
existing call ‘On Hold’, while you answer the new call. You can then place the new call
‘On Hold’ and return to the original call by again pressing *. This procedure can be
repeated as many times as necessary. Note - The * command for this function is fixed
and cannot be changed. Both calls will be terminated whenever you hang up your
telephone.
