Page 2
Natcomm
PRODUCT DESCRIPTION
This User Guide describes the installation and operating instructions of our
DS5
model DOOR STATION Controller. It is designed to connect to a SPECIALLY
DESIGNED Surface Mount or Flush Mount DOOR PHONE, as described on P3.
It is designed to connect to an
ANALOGUE EXTENSION
of any PBX or other
Multi-Line telephone system, or an FXS or ATA port of an IP or Cloud Phone
System. To use DS5, it is necessary that the Telephone System can be
programmed to HOT DIAL when the Analogue telephone extension that it is
connected to goes ‘Off Hook’. DS5 produces an ‘Off Hook’ condition when
triggered by the attached Door Phone. It will then remain ‘Off Hook’ until it detects
standard AUSTRALIAN ‘Hang Up’ tones from your telephone system.
If your Telephone System CANNOT be programmed to HOT DIAL, then you will
need to use our Model DS6 device, as it can be programmed to DIAL an internal
telephone extension or external telephone number.
ONE or TWO Door Phones can be connected to the DS5 unit (they must be
connected in parallel with each other). If you use TWO Door Phones
connected in parallel, either Door Phone can trigger the Door Phone call and
Audio will be present at both Door Phones at the same time.
If you wish to operate 2 completely separate Door Phone zones, when using 2
Door Phones, you should use an additional DS5 connected to an additional
Analogue telephone extension. Each Door Phone will then have separate audio
communication.
Model DS5 Has a Single Lock Control facility.
It is designed to allow you to unlock your gate or door from the answering telephone.
The DS5 Relay is a Dry Contact Relay, rated at 12V/1A.
Alternative Controllers are available which provide the following features:
DS4 - For PBX Extension or FXS/ATA connection, no lock control
DS5 - For PBX Extension or FXS/ATA connection, single lock control
DS6 - PBX Extension or FXS/ATA connection, dual lock control, with dial out
DS-SIP – Designed for direct Internet or Internet connection, via DHCP
has dual lock control