5
NARVON
ATTENTION
Before any disassembly and/or cleaning procedure,
make sure that the dispenser is disconnected
from its power source.
FIG 1
FIG 3
FIG 2
5. CLEANING PROCEDURES
5.1 Disassembly
5.2 Cleaning
•
The unit must be cleaned and sanitized daily in order to ensure safe and efficient operation, while guaranteeing a
quality product.
•
The unit does not come pre-sanitized form the factory. Before serving products, the dispenser must be disassembled,
cleaned, and sanitized.
•
DO NOT attempt to wash any machine components in a dishwasher.
•
Before any disassembly and/or cleaning procedure, make sure that the dispenser is disconnected from its power source.
•
When cleaning the machine, DO NOT allow excessive amounts of water around the electrically operated components
of the unit. Electrical shock or damage to the machine may result.
1 .
Empty all remaining liquid from the bowls into a container.
DO NOT proceed without emptying the bowls.
2 .
Remove cover from the bowl.
3 .
Remove the empty bowl by gently pulling lever (1) and its
front side (faucet side) up and off bowl gasket. (Fig. 1)
4 .
Remove the bowl gasket.
5 .
Remove the pump impeller from its location.
6 .
Push the dispensing handle (1) and gently remove the pinch
tube from its seat (2). (Fig. 2)
7 .
Gently remove the piston and unfasten the dispensing tap
assembly from the bowl. (Fig. 3)
8 .
Slide drip tray out and empty it.
1 .
Users should utilize the three sink method to properly clean all components:
a) Fill one basin with a neutral cleaning detergent mixed in lukewarm water.
b) Leave one basin empty for rinsing.
c) Fill a third basin with sanitizing solution mixed in lukewarm water.
2 .
In the first basin, Thoroughly wash all components, except the lid, in the mild cleaning detergent with a soft cloth
or sponge.
3 .
Rinse all components in water.
4 .
After rinsing, use a soft cloth or sponge to wipe down all of the components in the sanitizing solution.
5 .
Rinse the components for a final time before leaving them out to dry.
6 .
Wash the lids and the evaporator plates separately with a mild detergent and a soft cloth or sponge.
Be careful not to damage any electrical components.
