3. INSTALLATION:
-
Fasten the attachment plate to the wall using the screws
included in the delivery in accordance with Fig. 1.2.
3 1. ELECTRIC CONNECTION
-
Connection of the sauna heater to the power supply may only
be carried out by an authorised electrician in accordance with
the valid regulations.
-
A rubber-sheathed cable of type H07RN-F or similar must be
used as the connection cable. The cross-section of the cable
and the fuse size are presented in Table 1.
-
The cross-section of the wires routed from the sauna heater to
the control unit must correspond to the power supply cable of
the sauna heater.
-
Turn the stone space and the connecting
box upside down.
-
Open the base of the connecting box
-
Connect the supply cable to the terminal
block in the connecting box of the heater.
3.2 Installing the temperature sensor
- Install the sensor in the area lined in Figure 2.
- Install the temperature sensor on the wall with
the screws included in the delivery
(2 pcs. Ø 2,9 x 16).
- The wiring for the temperature sensor can
be embedded.
- Connect the sensor to the circuit plate
- Connect the end of the conductor, the one with
no connector in place, to the temperature sensor.
You can cut the conductor to a suitable length.
Figure 1.
min. 2 cm
min. 20 cm
max 3
0 cm
A
A
B
C
D
E
10 cm
Figure 2.
NARVI NC 6
NARVI NC 9
120
140
TYYPPI
X min. mm
min. 250
278
375
Figure 1.2
