Napoleon LD485, Руководство пользователя

Страница: 6 / 56

www.napoleongrills.com
6
EN
Lighting Instructions
Off Position
Left
Burner
Side Burner
Right
Burner
Left Centre
Burner
Rear
Burner
Side Burner Igniter
Right Centre
Burner
WARNING!
Open lid.
WARNING!
Ensure all burner controls are in the off position. Turn on the gas
supply valve.
Main Burner
Lighting
Rear Burner Lighting
(Rotisserie Burner) (if equipped)
Side Burner Lighting
(If equipped)
1. Open grill lid. 1. Open grill lid. 1. Open side burner cover.
2. Push and turn any main burner
knob slowly to the ’hi’ position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
2. Remove the warming rack. 2. Push and turn side burner
control to high position.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the ‘off position and repeat
step 2 several times.
3. Push and turn the rotisserie
burner control knob slowly to the
‘hi’ position. This action will ignite
the pilot flame which will in turn
light the burner. If the pilot lights,
continue to push down on the
burner control knob until the burner
lights then release.
3. Press and hold igniter button
until burner lights, or light by
match.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the ‘off’ position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
4. If the burner does not ignite, then
immediately turn the control knob
back to the ‘off’ position and repeat
step 3 several times.
4. If the burner will not ignite
within 5 seconds, turn the control
knob to the ‘off’ position and wait
5 minutes for any excess gas to
dissipate. Either repeat steps 2
and 3 or light with a match.
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
valve to high.
5. If the burner will not ignite within
5 seconds, turn the control knob to
the ‘off’ position and wait 5 minutes
for any excess gas to dissipate.
Either repeat steps 3 and 4 or light
with a match.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.