Napoleon BGD90NT-E, Инструкция по установке и эксплуатации

Страница: 47 / 112

47
W415-1107 / 07.24.12
12.2 GLASS / DOOR REPLACEMENT
A.
Place the door frame face down careful not to scratch the
paint.
B.
Center the gasketed glass inside the door frame with the thick
side of the gasket facing up.
C.
Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not
to break the glass.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1A
12.3 NIGHT LIGHT
TM
REPLACEMENT
FIREBOX TOP
NIGHT
LIGHTS
Your comes equipped with 2 “Night Lights™”. The lights have
been pre-wired and is controlled from the remote control.
If in the event the lamps or lens need replacing, follow these instructions.
Shut off breaker at main power supply.
Remove the four screws that secure the lens frame to the Firebox top.
This frame retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with
a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts
only, as lamp and lens are special “high temperature” products.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the holes in the housing lamp may be observed. The
holes in the lamp housing are necessary for ventilation and must not be
covered.
GASKET
LENS
FRAME
COLOURED SIDE UP
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER