NAPCO Net.Link NL-RCV-RMPCUL, Инструкция по установке, программированию и эксплуатации

Страница: 6 / 28

6
REAR PANEL
The descriptions that follow apply to the images above, from
left to right, as follows:
•
Power Input Connector - Connects to a standard
110VAC three-pronged input jack (supplied).
(Current draw = 1.2A max).
•
Main Power Switch - Switch for main Receiver
power supply. Note: This switch only supplies AC
power and does not cause the software to run.
COM Card:
•
COM1 - Serial port used for output connection to an
Automation Host computer. Electrostatically protected
for connection to an automation system.
•
LPT1 - Standard DB-25 female parallel printer socket.
Connect to the approved printer using a standard 36-pin
Centronics cable.
LAN Card:
•
LAN1 - Primary connection to the Net.Link Receiver,
and must be connected to the router.
•
LAN2 - Interlink connection RJ-45 crossover cable (e.g.,
NAPCO part #W943). Required only for Hot Backup
failover configuration (see page 7).
Relay Card:
Top connector contains a terminal block and a receptacle:
•
Trouble Relay - A normally closed dry contact relay. The
relay is activated upon power-on of the system (open
when powered) and closes when software resets, over-
temperature condition or power supply problem exists.
Note: Do NOT connect anything to reserved recepta-
cles.
Rear Housing Description
FIG. 2: REAR PANEL
COM1
(Reserved)
LAN1
(Reserved)
Trouble
Relay
COM Card LAN Card Relay Card
Power Input
Connector
Main Power
Switch
LPT1
LAN2
(Reserved)