NAPCO Gemini C
-
Series Control Panel Installation Instructions
--
Volume 3
Installation Instructions, Volume 3
Page 7
Enclosure Dimensions (WxHxD):
Inches: 13.875" x 12.375" x
3.80" (enclosure not provided with the GEMC
-
12V2ABOARD)
GEMC
-
12V2APS
-
R SPECIFICATIONS
Electrical Ratings
Primary Input Power:
120VAC, 60Hz, 60W (NAPCO TRF
-
14).
Secondary Input Power:
Two 12AH batteries maximum.
Total Output Power:
2.1A minus selected charging current. (see
JUMPERS
section for charging current selections).
Two Auxiliary Power Outputs:
12V Regulated, 1.5A maximum each;
0.80A @ 12V maximum standby current for 24 hours (see
GEMC
-
12V2APS BATTERY / CURRENT SPECIFICATIONS
tables).
Standby Current:
40mA for main board (less 40mA standby current
for power supply board).
Housing
The GEMC
-
12V2APS comes complete with transformer, enclosure and
ample room for standby batteries. Each model requires either two 12V
4AH, 4.5AH, 5AH batteries, two 12V 7AH, 7.5AH, 8AH batteries or two
12V / 12AH batteries.
Modules Wired to the Fire SLC Bus:
For the devices listed below, refer to PCD
-
Windows Quickloader down-
load software's calculation tools.
Fire or Burglary Bus Wire Gauges
Modules Wired to the Burglary SLC Bus:
GEMC
-
BSLC
-
1PT Single Point Expander
Electrical Ratings
Input Power:
13.6
-
16.3VDC, 2mA supplied by GEMC
-
BSLC control
unit.
Output Power:
Zone Loop Ratings: 16V, 0.31mA, 0.34mA short.
Maximum Zone Loop Resistance:
300
Ω
.
Maximum Wiring Length:
3000' (#16 AWG). Refer to GEMC
-
BSLC
documentation (WI1648) for complete wiring information.
Operating Temperature:
32° to 120°F (0° to 49°C)
Refer to PCD
-
Windows Quickloader download software's calculation
tools for 24V standby current calculation.
GEMC
-
BSLC
-
4PT Four Point Expander
Electrical Ratings
Input Power:
13.6
-
16.3VDC, 3mA supplied by GEMC
-
BSLC control
unit.
Output Power:
Zone Loop Ratings:
16V, 0.31mA, 0.34mA short per zone.
Maximum zone loop Resistance:
300 ohms.
Maximum Wiring Length:
3000' (#16 AWG). Refer to GEMC
-
BSLC
documentation (WI1648) for complete wiring information.
Operating Temperature:
32° to 120°F (0° to 49°C)
Refer to PCD
-
Windows Quickloader download software's calculation
tools for 24V standby current calculation.
GEMC
-
BSLC
-
PIR Burglary SLC Passive Infrared Sensor
Coverage (L x W):
50 feet x 50 feet (15.2m x 15.2m) at 68°F (20°C),
typical (with High Sensitivity Jumper "
SEN
" installed) 30 feet x 35 feet
(9.1m x 10.6m) at 68°F (20°C), typical (with Normal Sensitivity)
Operating Temperature:
14°F to 120°F (
-
10° to + 49°C)
Mounting:
Wall or corner, 6
-
12 feet (3.6m) max.
High Temperature Set Point:
90°F +/
-
4°F
Low Temperature Set Point:
40°F +/
-
4°
RATINGS
Electrical Ratings
Input Power:
13.6
-
16.3VDC (supplied by GEMC
-
BSLC module),
19mA.
Output Power:
(not applicable)
Maximum Wiring Length:
2000 feet (#16 AWG). Refer to GEMC
-
BSLC documentation for complete wiring information.
Unit shall be connected to model GEMC
-
BSLC which is employed in
the GEMC C
-
Series control panel which is provided with a minimum of
4 hours standby on battery power.
PHYSICAL
Dimensions
(HxWxD): 3.3in x 2.5in x 1.9in (8.4cm x 6.4cm x 4.8cm)
Shipping Weight:
5oz. (142g)
GEMC
-
BSLC
-
DT Burglary SLC Dual Technology Sensor
General Coverage
with standard wide
-
angle lens, measured indoors
at 68°F (20°C), typical: 50 feet long x 40 feet wide; "Look Down" zone
added.
Operating Temperature:
14° to 122°F (
-
10° to +49°C)
Mounting:
Wall or corner, 6
-
9.8 feet (2
-
3m) max.
Microwave Frequency:
10.525GHz ±25MHz
Physical Dimensions:
(HxWxD) 4.6 x 2.9 x 2.9 in.
Shipping Weight:
1.0 lb (454g)
Electrical Ratings
Input Power:
13.6
-
16.3VDC supplied by model GEMC
-
BSLC, 19mA.
Maximum Wiring Length:
2000' (#16 AWG). Refer to GEMC
-
BSLC
documentation for complete wiring information.
Unit shall be connected to model GEMC
-
BSLC which is employed in
the GEMC C
-
Series control panel which is provided with a minimum of
4 hours standby on battery power.
GEMC
-
BSLC
-
RLY Burglary SLC Single Point Relay Module
Electrical Ratings
Input Power:
Voltage:
13.6
-
16.5VDC (connected to the GEMC
-
BSLC).
Current:
Standby, 3.0mA + 5.0mA with energized relay.
Note:
The GEMC
-
BSLC
-
RLY is equivalent to 5 devices (and have a
maximum distance of 3000 feet per home run when using 16AWG
wire). See WI1648.
Output Power:
Form C dry contact. Wire only to power
-
limited cir-
cuits.
UL Contact Ratings:
30VDC, 2A and 30VAC, 1A (resistive load).
Maximum Wiring Length:
3000' (#16 AWG). Refer to GEMC
-
BSLC
documentation for complete wiring information.
Dimensions (inches):
Width: 1½ (38mm) Height: 3⅛ (79mm) Depth:
1 (25mm)
Operating Temperature:
32° to 120°F (0° to 49°C)
GEMC
-
BSLC
-
GB: SLC Glass
-
Break Detector with Tamper
Electrical Ratings
Input Power:
13.6
-
16.3VDC, 8mA supplied by GEMC
-
BSLC control
unit.
Maximum Wiring Length: 3000 feet (#16 AWG). Refer to GEMC
-
BSLC
documentation (WI1648) for complete wiring information.
Operating Temperature: 32° to 120°F (0° to 49°C). Refer to the PCD
-
Windows Quickloader download software calculation tools for 24V
standby current calculation.
Gauge (solid) Resistance (
Ω
)
Length (
ft
) Max. Current (ma)
22
16.8
1000
120
8.4
500
240
4.2
250
450
18
6.6
1000
240
3.3
500
480
1.65
250
850
16
4.2
1000
480
2.1
500
850
1.1
250
1700
14
2.6
1000
600
1.3
500
1000
.65
250
2000
12
1.7
1000
750
.85
500
1500
.51
300
2000
•
FWC
-
FSLC
-
CZM
•
FWC
-
FSLC
-
DUCT
•
FWC
-
FSLC
-
EZM1
•
FWC
-
FSLC
-
EZM2
•
FWC
-
FSLC
-
HEAT
•
FWC
-
FSLC
-
ISO
•
FWC
-
FSLC
-
PROG2
•
FWC
-
FSLC
-
PULL
•
FWC
-
FSLC
-
RM2
•
FWC
-
FSLC
-
SMK
•
FWC
-
FSLC
-
SOM1
