NAPCO F-TP Touchpad, Руководство по установке

Страница: 5 / 12

5
Test F-LTRANS
Note:
Transmitters
CANNOT be programmed
with their covers on. Remove
all transmitter covers.
Unlock and open door .
While pressing and holding
the tamper switch, insert bat-
tery (as shown), then release
the tamper switch.
19
Install the F-TP Touchpad
Face
Double-check all connections to the
F-TP Touchpad using the wiring dia-
gram as a guide. The antenna must
be carefully pushed through the hole
in the case and dangle down the in-
side of the wall (see step 3). Snap
the front of the F-TP Touchpad onto
the base by first inserting the 2 slots
in the top onto the corresponding
tabs on the base and then snapping
the bottom into place.
24
IMPORTANT: Seal
access holes
First create a service
loop of wires that is long
enough to allow the receiver
button to be pressed and the
LED to be observed.
Then seal the access holes
with putty (supplied) to ensure
F-TP Touchpad is air tight.
This important step is neces-
sary to prevent air drafts from
entering the F-TP Touchpad
from the wall cavity.
23
(Cont'd)
For a few seconds, the trans-
mitter will begin a self-diagnostic
process, then the LED inside the F-
LTRANS wireless transmitter will
flicker, indicating the F-LTRANS is
transmitting a signal to the receiver.
The Touchpad LED will stop flicker-
ing and a chime will sound--
indicating that the transmitter is suc-
cessfully programmed into the
Touchpad memory.
20
Test Transmitters
1. Close the door. The Touchpad should indicate
"READY".
2. Press STAY (the STAY light flashes).
3. Engage the deadbolt. Both the ARMED and STAY lights
on the Touchpad should turn on (the system armed
STAY).
4. Disengage the deadbolt and the system should disarm and
turn back off (READY light turns on).
5. Open the door. The Touchpad should sound a chime.
If there is a problem, see Troubleshooting on page 9.
To learn a second transmitter, start again at step 17.
21
Multiple Transmitters--Notes
The Primary transmitter that is lo-
cated in the same room as the
Touchpad is designated as
"Transmitter #1",
and its jumper
must NOT be installed .
If there is a Secondary transmitter
installed ("Transmitter #2"), it MUST
have a shunt on the Address
jumper. See page 2 for more infor-
mation.
Remove all transmitter
covers before proceeding.
17
Test Transmitter Signal Level
Test the transmitter to confirm signal strength. Press and
release the tamper switch. The receiver LED should flicker
in unison with the transmitter LED; if not, there is a problem
with the installation (see Troubleshooting on page 9).
Close the Transmitter Case
Snap the front of the Transmitter cover onto the base by
inserting the 2 slots in the top onto the corresponding tabs
on the base and then snapping the bottom into place.
22
J1
Jumper not installed
J1
Jumper installed
J1
J1
LEARN TRANSMITTERS AND TEST SYSTEM
Prepare Receiver to
Learn Transmitters
With all wiring in place, apply
power to the control panel. (the
Touchpad receiver will power up)
To ensure that the receiver is
cleared of all data, use a pen tip
to push and hold the button in
the center of the Touchpad (see
illustration) until the LED is on
steady, then release the button.
The LED will start flashing, indi-
cating the receiver is in Learn Mode and ready to learn
new transmitters.
18
Push Button
(use pen tip)
LED
Antenna
Tamper
Switch
LED