25mm
Flat end
After several hours of running the wire wool regenerators might need replacing.
Make sure the engine is
completely cooled down
and remove the tube from the engine.
Remove the old regenerators from the tubes using long tweezers.
The insides of the tubes can be cleaned with a small brush if it is dirty.
The regenerator material is "very fine 000" grade steel wool.
Form the spare regenerator into a cylinder with a flat end and insert into a tube. Push it in with the
flat end of a pencil until it is 25mm inside the tube.
It is important that the end of the regenerator is flat and 25mm from the end of the tube. Tamp the
end with the pencil if needed.
Repeat for the 2nd tube and refit both tubes to the engine.
Nano Flux Twin Assembly instructions page 27 of 27
Copyright Kontax Engineering Ltd 2019
