NANO 3 series, Руководство пользователя

Страница: 12 / 24

Page 12
nano purification solutions.
17-110-0140
10. Mechanical Installation
Once the dryer has been located into position, install ball valves and pipe work to ready the
unit for connection to inlet and outlet pressure piping.
The diameter of the pipes must be sufficient to allow unrestricted inlet air supply to the dryer
and to the application as shown in the table below.
Pre and high efficiency filtration is recommended at the inlet to the dryer. In extreme
conditions a water separator is recommended at the inlet.
Ensure that each filter condensate drain is suitably piped away and any effluent is disposed
of in accordance with local regulations.
It is important to ensure that all piping materials are suitable for the application, clean and
debris free. The diameter of the pipes must be sufficient to allow unrestricted inlet air supply
to the equipment and outlet gas / air supply to the application.
The dryer is supplied with an integrated exhaust silencer.
All components used within the system must be rated to at least the maximum operating
pressure of the equipment. It is recommended that the system be protected with suitably
rated pressure relief valves. It is also recommended to install the dryer with a bypass to
facilitate servicing.
Ref. Ref. Description Description
1
5 Ball Valve 2” or 2.5” Piping
(as required by the dryer)
2 6 Water Separator Series 3 Dryer
3 Pre-filter (Inlet)
4 High efficiency filter
5
5
1
2
6
3 4
1