NANAWALL PRIVASEE OWNER’S MANUAL
PAGE 10 OF 15
After final adjustments make sure to tighten down the
set screw to secure the bolt/axle from turning.
Step D3
After you adjusted all sliding panels, measure the width
for the single action offset end panel or non-entry offset
end panel again and make sure it fits into the opening.
See Sheet 9 of the Installation Manual.
Now you can start drilling holes for sockets! Do not
install the single action offset end panels or non-entry
offset end panels, yet!
E. SOCKETS
Holes in the floor for the sockets have to be made at
exact precise spots. There is no second chance if the
hole/slot location is off.
See Sheet 10 of the Installation
Manual.
Step E1
With a laser, find the center line of the head track on the
floor along the length of the opening, and mark it with a
chalk line. Close the unit such that the panels are in the
correct closed position. Make sure the panels are straight
and the correct 3/16” (4 mm) gap between panels is
maintained.
Step E2
Start with the panel furthest away from the parking bay
and add blue masking tape underneath the approximate
location of the locking bolts. Slowly and carefully engage
the locking points until it touches the tape. The tip of the
locking bolts should make a mark on the blue tape that
would be the center point of the socket hole.
Step E3
From the custom product drawings and the locking type
on the panels, drill the appropriate size socket holes. If
concrete, use a diamond core drill bit with the proper
diameter size.
Step E4
Slide the proper sockets into the holes. If necessary, use
suitable material to fix them in place.
F. INSTALLATION OF SINGLE ACTION OFFSET
END PANEL WITH FLOOR CLOSER
Step F1
After you adjusted all sliding panels, measure the width of
the single action offset end panel again and make sure it
fits into the opening.
Step F2
Take the top hinge pin for the single action offset end
panel out of the accessory box. Slide it inside the top
offset hinge on the panel and make sure that the set
screw is loose and allows the pin to slide in with ease.
Step F3
To install the panel, please lift the panel up and position
the center of the axle of the bottom hinge installed to the
panel profile over the center of the bottom hinge fixed to
the side jamb and lower it down. Then align the top hinge
with the pivot box attached to the top track. Line up both
hinges and connect them with the hinge pin. Secure the
hinge pin from the side with the set screw. Close the
single action offset end panel slowly and check all the
reveals. Make sure that the panel is not binding or hitting
the adjacent sliding panel.
For height adjustments, please use the screws inside of
the cement box surrounding the body of the floor closer.
For adjustments in width, please loosen the 2 screws at
the top holding the pivot box in place.
Step F4
Before you finally tighten down all screws, make sure that
all dimensions are set correct, the panel can be opened
and closed with the right clearance and check if the panel
is plumb and level. The last steps are to screw on the
