8
Manual
EASY FLOW
Meeting the requirements for using the machine, operating and repair according to
the manufacturer's instructions and strict compliance with them is a condition of
proper use.
Failure to comply with the above rules may lead to hazards for the operator and
bystanders, as well as damage to the unit. NAMYSLO Damian Namysło is not
responsible for damages resulting from this.
2.1. Connection of the aggregate to the tractor
Before connecting or disconnecting the aggregate with the three-point suspension
system, check that the tractor control levers are in a position in which the
unintentional raising or lowering of the lifting arms will not occur.
When connecting the machine to a three-point linkage, make sure that the
connection systems are in the same category.
There is a risk of crushing or cutting in the linkage zone of the linkage. When
starting the lift, nobody may be between the machine and the tractor.
2.2. Hydraulic system
When connecting the hydraulic system hoses to the tractor, make sure that there is
no pressure in the system. However, when disconnecting the system, lower the
machine to the ground, reduce the pressure and turn off the engine of the tractor.
Sockets and plugs of the hydraulic system should be properly marked to avoid
errors during connection. Incorrect connection of the hoses can lead to danger for
the operator. When replacing installations, new hydraulic hoses must have the
same technical specifications as those replaced.
