NAMCO EXCELEENA, Инструкция по эксплуатации

Страница: 15 / 22

Be sure to work with two people as it is heavy.
(1) Open the control panel cover. (See
Page 10 7-1 "How to remove the control
panel cover " )
(Working is easier if you remove the
control
panel cover completely .)
(2) Open the face panel. (Refer to P11 7-2 "How to open the face panel")
(3) Remove the four hexagon bolts (M8X20) that secure the monitor assembly.
(4) Pull out the monitor assembly until the end boss hits the slide guide.
(5) Rotate 90 ° in the direction of the arrow in Fig. 10 (clockwise) to make a
vertical
screen.
End Boss
Figure
9
Figure 10
(6) Secure the monitor assembly by replacing the four hexagon bolts in step 3
(7) Remove the eight screws (M4X10) that secure the monitor bezel.
(8) Rotate the monitor bezel 90° to install it.
(9) Replace the eight screws (M4 x 10) that secure the monitor bezel
※ When changing from the vertical screen to the horizontal screen, rotate it
90°in the opposite direction of the arrow and attach it so that the monitor
remote adjustment board is on the lower side.
※
If the orientation of the image is upside down, refer to the instruction manual
of the G ame PC board and flip it.
-1 3-
7 ­ 4 How to change the orientation of the monitor assembly
Slide Guide