NAMCO Air Combat, Руководство оператора

Страница: 45 / 68

Guard PCB Assembly Replacement
BE SURE TO TURN THE POWER OFF
BEFORE CONNECTING GUARD ASSEMBLY
If one of the four drive assemblies is out of order, the game can be made operational
with the remaining playfields available by using the Guard PCB Assembly provided
in the Convenenience Pack. Install the PCB Guard Assembly as follows:
1) Insure that the game power is off.
2) Open the back door of the Main Cabinet and check the non functioning drive
assembly for any disconnections, looseness, or mechanical failure.
3) If no obvious trouble is detected, remove the connector from the non function-
ing drive assembly and connect the Guard Assembly in its place. Refer to
table below for proper connections.
r
B A D
D R I V E
ASSEMBLY
Drive A
Drive B
Drive C
Drive D
C O N N E C T O R C O N N E C T O R
be CONNECTEC
R E M O V E D GUARD
Table 8-2, ASSEMBLY CONNECTIONS
4) Turn power back on.
a) If no error indication (Section 8-2) is given when power is turned back
on, the game is ready for continued play with the remaining drive
assemblies.
b) If error indication is still given after properly connecting the Guard
Assembly, contact your distributor, or Namco Technical Service.
N O T E : In the case of a non functioning Drive Assembly to which a Guard
Assembly has been attached, the Hit Sensor, Right Limit, Left Limit and
Center Sensor all remain active. Accordingly, during game play, a hitting
sound is generated even if crabs are not hit, and points are scored.
5) Since the Guard Assembly is for temporary use only as an alternative to a non
functioning drive, you should have the “bad” drive repaired or replaced as
soon as possible for restoration of normal game play.
6) Keep the Guard Assembly connected and remove and return the non function-
ing Drive Assembly to your distributor for repair or replacement. See section
(following) for Drive Assembly removal procedure.
1 1