Nakayama PS5000, Руководство пользователя

Страница: 14 / 37

110
tool so that the cutting tool swings just over the
ground without the need to move the appli-ance
with your hands. Put on the carrying harness and
close the clasps so that they click into place As
shown in Figure 3b, pull on the belt to position
the carrying harness centrally on your body and
adjust the upper body size. To tighten the two
shoulder straps, pull on the two shoulder straps.
To ensure to the correct position of the appliance
on the carrying harness, pull the belt as show
Hook in the carabiner and secure it with the red
strap on the quick release mechanism.
Now take the appliance and hang it, as shown
in Figure, so that the carrying lug clicks into the
carabiner . The carrying lug can also be moved
by loosening the screw and sliding it to achieve
the optimum orientation of the appliance.Setting
the cutting height
• Put on the carrying harness and hook in the
appliance.
• Use the various belt straps on the carrying
harness to adjust the optimum working and
cutting position.
• Perform a few circular movements without
starting the engine in order to find the ideal
shoulder strap length.
• The carrying harness is equipped with a quick-
release locking mech-anism. Pull on the red strap
if you have to release the appliance quickly.
CAUTION!
• Always use the carrying harness when you are
working with the appliance. Put on the carrying
harness as soon as you have started the engine
and it is ticking over. Switch off the engine before
removing the carrying harness.Fuel and oil
• Only use a mixture of unleaded petrol and
special 2-stroke engine oil. Mix the fuel mixture
in accordance with the fuel mix table.
• Add the respective correct amounts of unleaded
petrol and 2-stroke oil to the supplied oil/petrol
mixing canister 6^ (see "Fuel mix table"). Then
shake the canister well.Fuel mix tableMixing
process: 33 parts petrol to 1 part oil.
Before use
CAUTION!
• Please pay attention to the statutory provisions
in the relevant noise protection regulations.
Before starting the appliance, always check that:
• The fuel system is not leaking.
• The protective equipment and cutting
equipment is complete and in perfect working
order.
• All screw connections are firmly tightened.
• All moving parts can move smoothly and freely.
Starting when the engine is cold
CAUTION!
• Never allow the starter pull cord to whip back
This could cause damage.
1.) Fill the fuel tank (see also the section "Fuel
and oil").
2.) Press the primer 6 times.
3.) Switch the on/off switch to "I".
4.) Pull the choke lever into position "".
5.) Hold the appliance firmly and pull out the
starter pull cord to the point of first resistance.
Now pull hard on the starter pull cord. The
appliance starts.
6.) If the engine does not start, repeat steps 4–5.
7.) As soon as the engine is running, press the
throttle to activate the automatic choke.If the
engine does not start after several attempts, read
the "Troubleshoot-ing guide" section.
CAUTION!
• Always pull the starter pull cord straight out.
Hold the handle of the starter pull cord firmly
when the starter pull cord retracts. Do not allow
the starter pull cord to whip back.
NOTE
• At very high ambient temperatures it is possible
that even a cold engine has to be started without
using the choke!
Starting when the engine is hot
(The appliance has been turned off for less than
15–20 minutes)
1.) Switch the on/off switch to "I".
2.) The choke lever does not need to be pulled
out to start a warm motor.
3.) Hold the appliance firmly and pull out the
starter pull cord to the point of first resistance.