Nakayama PS5000, Руководство пользователя

Страница: 15 / 37

111
Now pull hard on the starter pull cord. The
appliance should start after 1–2 pulls. If the
appliance still hasn't started after 6 pulls, repeat
steps 1–7 under "Starting when the engine is
cold".
Turning the engine off
Emergency stop sequence
If you need to stop the appliance immediately,
switch the on/off switch to "0".Normal sequence
• Release the throttle lever and wait until the
engine has slowed down to its idling speed. Then
switch the on/off switch to "0".
CAUTION!
• The 3-section cutting blade must be stationary
when the engine is idling. If the 3-section cutting
blade is rotating adjust the carburettor!
Optimal working procedures
Before using the appliance, practice all working
techniques with the engine stopped. Extending
the cutting filament
To lengthen the cutting filament, rev the engine
to full throttle and tap the strimmer on the
ground. The filament extends automatically. The
knife on the cutting filament protective guard
cuts the thread to the permissible length.
CAUTION!
Grass/weed residues can get caught under the
protective guard.
• Remove the remains using a scraper or similar
item when the engine is switched off.
Various cutting methodsTrimming/mowing
(3-section cutting blade or strimmer)
• Swing the appliance in a scything motion.
• Hold the cutting tool parallel to the ground and
set the desired cutting height.
Low trimming (with strimmer)
• Hold the appliance with a slight incline to the
ground. Al-ways cut away from your body. Never
pull the appliance towards you.Short mowing
(with strimmer)
• Short mowing removes all the vegetation right
down to the ground. Angle the strimmer 30° to
the right. Set the handle to the desired position.
Cutting against trees/fences/foundations (with
strimmer)
NOTE
• The filament will wear or fray quickly if it
comes into contact with trees, rocks, walls or
foundations. The filament will break off if it strikes
fence mesh.
CAUTION!
• Do not use the appliance to remove any objects
from footpaths, etc.! The appliance is powerful
and can fling small stones or other objects
15 metres or more and may cause injuries or
damage to cars, houses and windows.
Wear safety goggles!
Jamming
Immediately turn off the engine if the cutting
tool becomes blocked. Remove all grass and
scrub from the appliance before restarting the
appliance.
Preventing kickback
When working with the cutting blade there is a
risk of kickback if the blade strikes against solid
obstacles (tree trunks, branches, tree stumps,
rocks or similar). This will result in the cutting
tool being catapulted back against the direction
of rotation. This can lead to the loss of control
of the appliance. Do not use the cutting blade
near fences, metal posts, boundary stones or
foundations. To cut weak shrubs, position the
appliance as shown in Fig. 6e to avoid kickbacks.
Working with the hedge trimmer Cutting
techniques
• The double-sided cutter bar allows cutting in
both directions or by using swinging movements
from one side to the other.
• For a vertical cut, move the hedge trimmer
evenly forwards or up and down in an arc.
• For a horizontal cut, move the hedge trimmer in
a scything motion along the edge of the hedge
so that cut branches fall to the ground.
• See fold-out page.
NOTE
• Remove thicker branches with a branch cutter.