Nakanishi E2280, Руководство по эксплуатации

Страница: 26 / 60

81
English
Pin
No. Code Function Input /
Output Description
5 SEL1 Count Pulse
Signal for
Setting
Motor Speed
(CNT_IN) Input ― One pulse will increase or decrease 1,000min
-1
in Spindle Speed depending on parameter
setting. (Refer to P106 " 18 - 4
⑦
Selection of External Speed Control Mode "
section.)
Speed Point
Select 1
(POINT 1)
Speed Point Signal can be selected. Speed
Point (When using Motor No. 1, "
" -
" ", and when using Motor No. 2, " " -
" ") can be selected by POINT 0 and POINT
1 signal combination. Refer to P79 " 15 - 3 - 2 (4)
③
Set by the Speed Point Signal " section.
Need to set parameter
. (Refer to P106
" 18 - 4
⑦
Selection of External Speed
Control Mode " section.)
6 RUN Rotating Output ' OFF (Open) ' : Stop
' ON (Closed) ' :
Rotating
Output shows that the motor is rotating.
7 DIR_OUT Rotating
Direction Output ' OFF (Open) ' : FWD.
' ON (Closed) ' : REV.
Output shows the direction of the Motor is
rotating.
8 ERR Error Output ' OFF (Open) ' : Error
' ON (Closed) ' : Normal
Output shows that error has occurred. Error code
will be displayed on Control Panel
②
.
When setting parameter , Error Output
Mode can be changed.
(Refer to P104 " 18 - 4
①
Setting of Error
Output Mode " section.)
9 SEL_MT Motor Select Output 'OFF (Open)' :
MOTOR1
'ON (Closed)' :
MOTOR2
Output shows that the selected motor is
MOTOR No. 1 or MOTOR No. 2.
10 GND Internal GND
for Motor
Speed Control
Voltage Output Internal CONTROLLER
GND
This GND will be used for " Motor Speed
Control Voltage (VR) ".
11 Vcc Internal Power
Source for
Motor Speed
Control
Voltage Output Internal Power
Source : DC+10V
Internal Power Source for " Motor Speed
Control Voltage (VR) ".
12 MOTOR_I Motor
Current
Monitor Output 2Amp / V,
0V
≦
MOTOR_I
≦
10V
Output Motor Current Monitor with Analog
Monitor Voltage.
2Amp / 1V. Max. 20Amp.
13 GND Internal GND
for Analog
Monitor Output Internal CONTROLLER
GND
This GND will be used for analog monitor
(MOTOR_I, SPEED_V, and LOAD).