Page 6 of 14
4/21 IOM-MAC-700-INST
Nailor Industries Inc. reserves the right to change any information concerning product or specification without notice or obligation.
UV LAMPS INSTALLATION
After installing UV-C lamps please make sure the lamps are connected properly. To do that –
1 Turn the unit ON while the unit door is open.
2 Press the safety switch.
CAUTION: DO NOT LOOK AT LAMPS DIRECTLY, USE APPROPRIATE PERSONAL PROTECTION EQUIPMENT.
3 If Lamps are not emitting, disconnect the lamp and turn it 180 degree and install again.
BULB REPLACEMENT:
Recommended: Replace the UV bulbs after 9,000 hours of use continuously or after 9,000 hours of use intermittently. Use
replacement bulbs exactly the same specific size and wattage as the original factory supplied bulbs. Note that the ultraviolet
radiation emitted by the bulbs will degrade over the 9,000 operating hours time and will no longer provide the intended benefit,
however, the characteristic blue glow may still be seen and generated.
HOUR METER AND RESET BUTTON:
MAC-700 is equipped with an hour meter that counts the number of hours that unit has been On. The UV-C lamps should be
replaced when the hour meter number reaches to 9,000. After removing the old lamps, while pressing the safety switch, hold
the rest button for 3 - 4 seconds to rest the hour meter and then install the new lamp.
Caution: To avoid damage to your eyes, Please make sure to rest the button before installing new lamps.
Figure 3. Hour Meter Reset Button
WARNING: SKIN OR EYE DAMAGE MAY RESULT FROM
DIRECTLY VIEWING THE LIGHT PRODUCED BY THE
LAMP IN THIS APPARATUS.
ALWAYS DISCONNECT POWER BEFORE RELAMPING
OR SERVICING.
REPLACE LAMPS WITH LAMP MODEL NO-1:
GPH508T5L/HO/4P, MANUFACTURED BY SHAOXING
SHANGYU YUP LIGHTING CO, LTD, NO-2: SEL-20-T5-HO
MANUFACTURED BY UV-RESOURCES.
