background image

Page 6

6. SYSTEM OPERATING INSTRUCTIONS

Your new system is now ready to be used.  Here are a few simple guidelines to follow when you are 
using your Nadair  Central Vacuum System:  Insert the wall  end of the hose into one of the  vacuum 
valves installed throughout your home, and you are ready to start, press the switch on the hose handle!

NOTE

In regards to the low voltage system:  All vacuum inlet valves are fitted with two (2) springloaded metal 
pins (see inside the valve opening). When the two (2) metal parts of the hose wall end are in contact 
with the two (2) pins inside the valve, the system is energized. You may now turn it on or off from the 
hose handle switch (if this option was selected).
The low voltage cable is connected in parrallel from every valve, it runs all along the pipe network and 
brings the power to the the remote switch so to remotely start or stop the power unit in all safety.
A standard flexible hose, not fitted with an interruptor, will start the power unit as soon as it is inserted in 
the valve opening.

7. SYSTEM  MAINTENANCE

FILTRATION SYSTEM

In  order  to  maintain  optimal  air 
quality in your home, the power unit 
comes supplied with a high efficiency 
HYBRID filtering system.

permanent 

polypropylene 

washable and reusable filter together 
with  an  optionnal 

22,5L

disposable 

filter bag.
The permanent filter must be in place 
at  all  times,  the  filter  securing  strap 
must be tightened just so as to insure 
no  fly-by  of  debris  into  the  motor 
housing.

IMPORTANT

This  Nadair  hybrid  power  unit  may 
be  used  with  or  without  a 

22,5L

 

disposable bag.
3 bags pak #: 

FD-22.5L-3NAD

The  disposable  bag  installs  as 
shown here :
1-Remove the debris canister.
2-Remove the dirt filled bag.
3-Install the new bag by twisting it.
4- Verify and clean (if necessary)

the permanent filter.

5- Replace the debris canister and

secure the latches.

NOTE

When replacing the  disposable  bag, make  sure  that  the rubber  diaphragm  is  correctly  installed  onto the 
intake PVC pipe. Make sure that the bag is not cut or damaged. Make sure that the canister is secured in 
place prior to restarting the power unit.  

It is recommended to replace the disposable bag or to empty 

the debris canister as well as to clean the permanent filter 3 or 4 times per year.

 If the system is used 

more frequently than normal, repeat the above procedure more often.

IMPORTANT

NEVER USE this system to pick up liquids, mud or combustible materials. To vacuum baking flower, talcum 
powder, cement or gypsum dust, will have for effect to obstruct and eventually clog the filter media; you have 
to clean the filter several time during and after such pick-ups. Otherwise the power unit performances will 
be affected, the motor will overheat and may be damaged.

MOTOR

This Nadair power unit  is equipped with a soft-start controler and a delayed stop.  A warning is automatically 
programmed after 500 hours of usage.  The inspection and the maintenance of this appliance must be done 
in  an authorized  service center. A Mini-breaker shall cutt-off power to protect the motor in the event of a 
power surge which may cause the motor to overheat. The low voltage technology system communicates the 
power unit status through a muticolor LED on the side of the unit.  Please consult the interpretation chart in 
section 8.

Содержание 600-AL-32









Отзывы: