Place the plastic spreader cover over the spreader tip and place
the diamond wire in the slot in the spreader tip with the nylon
roller above the spreader arms. Feed the monel seizing wire from
the back side of the tip with on end on each side of the diamond
wire. Lead the wire out of the tip.
Cross the seizing wire over the diamond wire and feed to the
back of the tip. Pull and twist tight with needle-nosed pliers.
Check the wire to be sure that it is held tightly in the slot, and
cannot come out (6).
NOTE: Be sure to tape all split rings to prevent snagging and
accidental loosening.
ROTATOR ARM
Attach the rotator wishbone to the mast (7). Remove the upper
nut on the rotator bolts and attach the arm to this bolt. The lower
bolt is there only to stop the arm from coming into contact with
the boom when sailing. Be sure to tighten both nuts after
installing the arm.
DOWNHAUL BLOCKS
Attach the downhaul swivel blocks to the base of the
mast as shown (8).
HALYARDS
Run the main halyard line through the masthead
sheave and back down through the luff groove in the
mast (9). Tie the halyard lock ring onto the end of
the halyard that exits the top of the mast using a
small bowline. Attach the large twist shackle to the
ring (10).
Spinnaker Halyard
Run the spinnake r
h a l yard up the star-
board side of the
mast,
through
the
spreader
ar m s,
through
the
bale,
around
the
cheek
bl o ck on the mast,
b a ck down through
the bale, and dow n
the outside of the
mast (11).