NABO GSV 1045, Инструкция по эксплуатации

Страница: 50 / 101

•
Observe the instructions on packagings when using such products.
•
If such detergents are in the form of tablets, never put them into the interior section or the
cutlery basket of the dishwasher. Always put the tablets into the detergent compartment in
the detergent dispenser.
•
They produce good results for certain types of usage only. If you are using this type of
detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
•
When the conditions of use of such products and the machine settings are appropriate,
they ensure savings in salt and/or rinse aid consumption.
•
Contact the detergent manufacturers if you are not obtaining good wash results (if your
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage: If you are using a combined detergent, then add rinse agent into your
machine ,switch the rinse agent settings into its lowest (1) position and active the tablet
detergent button in order to obtain better results.If the water hardness level is above level 4,then
it is necessary to fill in the salt container with salt.
İ
t is not recommended to use combined
detergents in fast programs.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in such
programs
.
Warning: Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
1
6
1.1.
F
illing the rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the
machine:
1.1. Filling the rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse
aid compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the
machine:
• Push the programme button and hold it down.
• Turn on the machine.
• Hold down the programme button until “rA” disappears from the display. Rinse aid set
follows water hardness set.
• The machine will display the current setting.
• Change level by pushing the programme button.
• Switch off the machine to save the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on
your dishes, decrease the level.