
Mono pull-out kitchen mixer
1. Identify all components and check for completeness, particularly before commencing installation.
2. Screw fixing rod to tap body and tighten it.
3. Fit flange to tap body, ensuring that the anti-rotational washer is fitted between the flange and the sink. if the flange is not
supplied, fit anti-rotational washer directly to the tap body.
4. Screw 2x flexible tails into tap body, do not over tighten.
5. Locate the tap assembly down through the tap hole in sink.
6. Slide the C shaped rubber washer and the C shaped metal washer onto the fixing rod up to the underside of the sink. To secure
the mixer in place tighten the fixing nut onto the fixing rods until they fully tightened against the C shaped metal washer.
A suitable spanner may be required to fully tighten the fixing nuts.
7. Connect the flexible tails to the hot and cold water supplies.
8. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
9. Check all joints and connections for any leaks.
Tap Body
Flange (if supplied)
Anti-rotational washer
C shaped rubber washer
Fixing rod
Fixing nut
Flexible tails
C shaped metal washer
www.Divapor.com