
Single lever pull-out kitchen mixer
1. Identify all components and check for completeness, particularly before commencing installation.
2. Screw fixing rod to tap body and tighten it. See Fig 1.
3. Ensuring that the anti-rotational washer is fitted the flange, then fit flange to tap body. Pull out hose must be through the hole
of the anti-rotational washer and the flange.
4. Screw 2x flexible tails into the tap body. Do not over tighten. See Fig 1.
5. Locate the tap assembly down through the tap hole in sink.
6. Slide the C shaped rubber washer and the C shaped metal washer onto the fixing rod up to the underside of the sink. To secure
the mixer in place tighten the thick fixing nut onto the fixing rod until they fully tightened against the C shaped metal washer.
A suitable spanner may be required to fully tighten the fixing nuts.
7. Fit hose retainer to pull out hose, slide hose retainer to the fixing stud, secure this into position using the thin fixing nut.
8. Fit adaptor to fixing stud and tighten.
9. Ensure that the sealing washer is fitted to the adaptor.
10. Connect pull out hose to the adaptor using an spanner. See Fig 2.
11. Fit counter balance weight to pull out hose in the position.
12. Connect the flexible tails to the hot and cold water supplies.
13. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
14. Check all joints and connections for any leaks.
Tap body
Anti-rotational washer
Flange
C shaped rubber washer
Thick fixing nut
Hose retainer
Thin fixing nut
Fixing rod
Flexible tails
Pull out hose
Sealing washer
Adaptor
C shaped metal washer
Counter balance weight
Fig 2
Flexible hose
Fixing rod
Fig 1
Hole for hose
www.Divapor.com