
Single lever pull-out kitchen mixer
1. Identify all components and check for completeness, particularly before commencing installation.
2. Screw fixing rods to tap body and tighten it. See Fig 1.
3. Ensuring that the anti-rotational washer is fitted between the tap body and the sink. Pull out hose must be through the hole of
the anti-rotational washer.
4. Screw 2x flexible tails into the tap body. Do not over tighten. See Fig 1.
5. Locate the tap assembly down through the tap hole in sink.
6. Slide the holder seat, C shaped rubber washer and the C shaped metal washer onto the fixing rod up to the underside of the
sink. To secure the mixer in place tighten the fixing nut onto the fixing rod until they fully tightened against the C shaped
metal washer. A suitable spanner may be required to fully tighten the fixing nuts.
7. Ensure that the sealing washer is fitted to the adaptor.
8. Connect pull out hose to the adaptor using an spanner. See Fig 2.
9. Fit counter balance weight to pull out hose in the position.
10. Connect the flexible tails to the hot and cold water supplies.
11. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
12. Check all joints and connections for any leaks.
Flexible hose
Fixing rod
Fig 1
Hole for hose
Tap Body
Anti-rotational washer
C shaped rubber washer
Adaptor
Holder seat
Fixing nut
Fixing rod
Flexible tails
Pull out hose
Sealing Washer
C shaped metal washer
Counter balance weight
Fig 2
www.Divapor.com