Nabis B08922 Скачать руководство пользователя страница 2

Water Regulations Requirements

It is important to ensure that the water supplies to your taps and mixers are connected in accordance with the Water
Regulations and good plumbing practice.
It is Wolseley’s recommendation and good plumbing practice that the supplies of hot and cold water to the products 

should be equal (balanced) pressures in order to provide a consistent flow. Supplies should be from a common source.

Please note: if a pump is to be installed to boost gravity supplies please refer to the pump manufactures instructions.
The hot and cold inlets for any of the products are hot on the left and cold on the right when viewed from the front of

the fitting. It is our recommendation and good plumbing practice that a service valve also should be installed up stream

in the inlet supply lines.

Pipe Connections

IMPORTANT. Before making any inlet pipe connections all supplies MUST be thoroughly flushed to remove any

debris.

Failure to do so could result in damage or low flow from the fitting.

General Installation Notes

• Care must be taken during installation to prevent any risk of damage to the product or injury to installer.

• Installation must be carried out by a qualified and competent person and in accordance with the instructions supplied.

• Installations must comply with all Local and National Water Authority Regulations and Building/Plumbing

  Regulations.

• Ensure that you have read and understood all sections of this manual before installation.

Water Supply Pressures

All fittings have been designed to function under the following conditions:

• Minimum supply pressure: 1.0 bar
• Maximum supply pressure: 5.0 bar
Generous flow rates are achieved at pressures as low as 1.0bar. At high pressures it maybe necessary to reduce
excessive flow rates by fitting stop or servicing valves in the supply line before the mixer or tap. These stop valves

facilitate ease of maintenance should it be necessary.

www.Divapor.com

Содержание B08922









Отзывы: