Rev. 3-12-13
Part #15-9000-30
www.NabcoEntrances.com
U30 Microprocessor Control
4-13
Initial Startup
8.►
Press TEST to ensure Door behavior is based on current settings.
a.
The Door will complete a full cycle then slow down at Latch Check point and Back Check point.
9. STD FUNCTION Y N
message will be displayed after the Test is completed.
a. This concludes the initial setup to factory settings.
10.►
If the U30 Microprocessor Control:
X
Does not need to be programmed with custom settings:
• Disconnect the Handy Terminal and instruct the building owner of the Slide
door’s operation.
X
Does need to be programmed with custom settings:
• Please refer to Chapter 5 “Adjustment Procedures” for detailed information.
