Adjustment Procedures
5-18
U30 Microprocessor Control
www.NabcoEntrances.com
Part #15-9000-30
Rev. 3-12-13
Section 5c: Special Function Adjustments
1.►
Upon initialization of the Handy Terminal, press the ENTRY
button until
SPECIAL FUNCTION Y N
is displayed.
2.►
To start the Special Function Adjustments program, press the Shift buttons to select Y.
3.►
Press Entry.
Special Function Adjustment
Adjustment
Description
Hold Close
(Using Motor Power)
Message will read:
HOLD CLOSE Y
Y
Directs the U30 Microprocessor Control to hold the Slide door closed.
N
Leaves Slide door free at closed position.
Holding Beam
Message will read:
HOLDING BEAM Y
Y
Opens Slide door when the Holding Beam is activated and door is in the closed position.
N
Keeps Slide door closed when the Holding Beam is activated.
Power On
Message will read:
POWER ON 0
● Determines how the door will react when the power is turned on after having been turned off
or interrupted. A typical example would be if the owner unlocks the door and opens it manually
before turning on power.
● The following (4) options are available:
Zero Slide door will slowly reach full closed position and is ready for normal operations.
One If Slide door is activated while closing slowly, the door will slowly reach the full open
position and then close.
Two Slide door will slowly reach the full open position then close.
Three Slide door stays in manual-open position until activated, then opens slowly and closes.
Manual Opening
Message will read:
MANUAL OPEN 0
● After the Slide door system has been completely set up and operating, a choice is offered on
how the door will act if manually opened from the fully closed position.
● The following (4) options are available:
Zero Slide door will remain in the same position it was manually opened to.
One When the Slide door is opened manually, it will power open.
Two After the Slide door has been manually opened, it will slowly close.
Three Slide door will power close while is being opened manually.
Reduced opening
Message will read:
RED OPENING Y N
● Enables the reduced opening of the door by following the instructions listed below:
1. Select Y and press the Entry button.
2. Manually slide the door to the desired open width and press the TEST button.
a. Slide door will close slowly, memorizing the point of reduced width.
● Reduced opening will only work after the Handy Terminal is disconnected and Reduced
Opening is selected on the Rocker Switch.
Recycle
On the U30 Microprocessor Control:
● Recycle is used to set the direction of motor rotation for hand of the Slide door. On previous U
series controls, Recycle was associated with the RECYCLE function.
