
28 of 53
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
www.NabcoEntrances.com
P/N C-00106
Rev 8-10-16
SECTION 10: INSTALL WEATHERING
Roller Assembly
DN 0119
FIXED SIDELITE
Slide Door
Weathering
Bo om Guide
FULL OPEN
Slide Door
Weathering
Swing Sidelite
Weathering
1/8”
BREAKOUT SIDE
Figure 39 Weathering Placement
10 .1 Fixed Sidelite Slide Door
1.
Slide Vinyl into the Brush Holder.
2. Secure Brush Holder to Bottom Rail of Slide door with #6 x 1/2 inch self tapping screws.
10 .2 Full Open
1. Slide Vinyl into the Brush Holder. Secure Brush Holder to Bottom Rail of Swing Sidelite with #6 x 1/2 inch self tapping screws.
a.
It is recommended to leave at least a 1/8 inch gap between the Edge of the Pivot Stile and the Brush Holder.
b. Allow 1/8 inch Vinyl to extend past the Brush Holder so the gap is filled.
c.
Failure to do so, will cause the Brush Holder to damage the Pivot Jamb Tube and/or keep the Swing Sidelite
from opening.
2. Breakout the Swing Sidelite. Slide Brush into the Brush Holder.
3. Secure Brush Holder to Bottom Rail of Slide door with #6 x 1/2 inch self tapping screws.
FIXED SIDELITE
Vinyl
DN 1030
FULL OPEN WITH TRACK
Brush
#6 x 1/2” Self Tapping Screw
7/8”*
7/8”*
Nominal Dimension*
Figure 40 Secure Weathering
10 .3 Apply Caulking Bead
1. Ensure the entire Door Frame is properly secured to the Rough Opening.
2. Apply caulking bead between the Door Frame and Rough Opening (inside and outside).
DN 0883
Caulk the top and both sides
of Door Frame
Caulk the Threshold
Figure 41 Caulk Position