
10 of 53
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
www.NabcoEntrances.com
P/N C-00106
Rev 8-10-16
DN 1017
Plumb Line + 1/8” to edge of Track
Header Cover
1/8”
4.5”
NONBREAKOUT SIDE
Figure 10 Plumb Line
SECTION 4: INSTALL THE FIXED SIDELITE
Slide Door
Fixed Sidelite
DN 0842
Figure 11 Fixed Sidelite, No Breakout
4 .1 Secure the Fixed Sidelite to the Pivot Jamb Tube and Header
1. Obtain (1) 1/4-20 x 1/2 inch Flat Head Screws provided by NABCO.
2. Go to the Strike Stile located on the Strike side of the Fixed Sidelite.
3. Locate the Cut Out at the Top.
4. Locate (1) Mounting Bracket that was preinstalled under the Bottom Lip of Header.
5. Lift and then angle the Fixed Sidelite until the Mounting Bracket is seated inside the Cut Out.
a.
There is room inside the Strike Stile for the Mounting Bracket to move around within.
b. Move the Fixed Sidelite forward so the Pivot Stile does not scrape up against the (3) Mounting Brackets that were
preinstalled on the Pivot Jamb Tube.
Figure 12 Slide Mounting Bracket into Cut Out
DN 1019
Moun ng
Bracket
Strike S le
Cut Out
6. Locate (3) Cut Outs on the side of the Pivot Jamb Tube.
7. Align and then slide the Fixed Sidelite until (3) Mounting Brackets are seated inside each Cut Out.
8. Continue to slide the Fixed Sidelite towards the Interior of the Building until both Mounting Brackets butt up against the
inside wall of the Pivot Stile.
9. Align all (4) Mounting Bracket screw holes with the Pivot Stile screw holes and the Strike Stile screw hole.
10. Secure (3) Mounting Brackets located on the Pivot Jamb Tube to the Fixed Sidelite with (3) 1/4-20 x 7/16 inch Phillips
Head screws.
11. Secure (1) Mounting Bracket located under the Bottom Lip of Header with (1) 1/4-20 x 1/2 inch Flat Head Screw.