N.KO B2 Air, Руководство пользователя

Страница: 9 / 15

9
11. Use
Important:
The equipment may only be used if it is fitted with blade plates that are equipped by our
supplier, respectively The maker of the equipment. These are 3-sided blade plates. The
equipment is fitted with 3X blade plates. It is strongly recommended to never use other than
original plates.
11.1 Setting the size of the cut
Caution:
When adjusting use work gloves and additional means of personal protection.
Operations must be performed with the machine at rest and upon disconnection
from lines of pressurized air.
 Disconnect the machine from the input of pressurized air.
 Loosen the arresting screw setting (pic.10.0.1 position D)
 Turn the guide plate (pic.10.0.1 position E) for setting the size of the cut. The current
setting can be subtracted from the integrated scale. The scale is only orientational and
the resulting cut may differ.
 Upon setting, again tighten the screw (pic.10.0.1 position D).
Important:
The maximum cut is 2mm wide (the spot height P pic.11.1.1). This cut must be attained via
several steps. It depends on the firmness of the material. We recommend performing a test.
Start with a smaller cut and gradually raise the value up to the moment that work with the
machine is still comfortable, and the plates retain the ability of a smooth cut without increased
vibrations.
We recommend starting a work journal in which it is possible to record the measured values
and your own procedure for machining.