N-Com basic kit 2, Инструкции пользователя и правила безопасности

Страница: 14 / 32

14

Position the neck roll slot, right side, in its housing on the Basic Kit2 (fig. 18).

Put the right cheek pad back in its original position, clicking the press-stud.
Note: If you assembled the Basic Kit2 with the battery, keep the recharge cable under
the neck roll. This can be used only when you need to recharge the system.

Look at the 15-pin connector from the outside of the helmet. Check that the
fastening clasp is properly inserted (A). If the fastening clasp is not properly
inserted, proceed as follows.

Detach the left check pad. Push the Basic Kit2 from the inside of the helmet,
until the fastening clasp clicks into place. The fastening clasp is rigid and the
clicking is evident. It is possible to make the operation easier by pushing the
external shell of the helmet and the Basic Kit2, in order to bring the two surfaces
together (B+C) (Fig. 19).
Caution: Always check the length of the chin strap and readjust it as necessary
according to specific helmet instructions.
Warning: After installing the Basic Kit2 inside the helmet, verify that the microphone
is positioned correctly in front of your mouth, adjusting the flexible part
accordingly. When the microphone is not used, you can move it to a more
comfortable position. When you receive a call or you need to use the microphone,
stop and reposition it accordingly.
Warning: The wind protector supplied with the helmet can make it more difficult to
open and close the chin guard when the microphone is installed.