N.A.T. NAT-MCH, Техническое справочное руководство

Страница: 21 / 32

NAT-MCH BASE-Module– Technical Reference Manual
Version 2.10 © N.A.T. GmbH 21
4.2.2 CON2: Extension Module Connector
Connector CON2 connects the NAT-MCH BASE-Module with the NAT-MCH CLK-
Module and/or the NAT-MCH HUB-Module .
Table 5: CON2: Extension Module Connector – Pin Assignment
Pin # AMC-Signal AMC-Signal Pin #
1 /SPISEL_CLKPCB /INT_HUB 2
3 GND GND 4
5 NC NC 6
7 NC NC 8
9 +12V +12V 10
11 +12V +12V 12
13 EXTREF_1_P +3.3V MP 14
15 EXTREF_1_N SPICLK 16
17 EXTREF_2_N EXTREF_2_P 18
19 MOSI MISO 20
21 GND /SPISEL_Hub-Module 22
23 SCL /Reset_CLK-Module 24
25 SDA /Reset_Hub-Module 26
27 GND GND 28
The I
2
C- and SPI- interfaces of Connector CON2 are connected to the respective
interfaces of the local Coldfire CPU.
4.2.3 JP1: Altera FPGA Programming Port
Connector JP1 connects the JTAG- or programming-port of the Altera FPGA device.
Table 6: JP1: Altera FPGA Programming Port – Pin Assignment
Pin # AMC-Signal AMC-Signal Pin #
1 DCLK GND 2
3 CONF_DONE +3.3V 4
5 /CONFIG /CECONF 6
7 DATAO /CSO 8
9 ASDI GND 10
4.2.4 JP2: LED-Module Connector
Connector JP2 connects the LED-Module via a ribbon cable.
Table 7: JP2: LED-Module Connector – Pin Assignment
Pin # AMC-Signal AMC-Signal Pin #
1 GND nRESET_LED 2
3 +3.3V MOSI 4
5 nSPISEL_LED MISO 6
7 GND/PDI-DATA* SPICLK 8
* Hardware version v3.5 reuses GND pin7 as programming pin to support incircuit
programming of the latest LED module version