10
ADJ USTING SE AT AND HANDLEBAR HEIG HT
Seat and handlebars can be raised and lowered with
the adjustment pins at the front and rear of the bike
frame, shown in the diagram on page 6.
Do not lift the seat or handlebar posts
above the MAX mark.
Do not use the product if the seat or
handlebars are not securely and tightly locked
into place.
Ensure power cord is out of the way
when adjusting the height.
Adjust the seat and handlebars with two
people due to the weight of the handlebars with
tablet attached.
4
3
2
1
1
2
3
CONNEC T POWER CORD
Thread the small end of the power cord from the
bottom of the mounting arm to the hole at the bend
in the arm. Pull the wire through the hole and connect
to tablet, allowing 8-10” of slack so the tablet can
swivel freely. Connect the wall adapter to the plug
below the flywheel and a grounded 120V wall outlet.
8-10”
1. Turn pins counterclockwise to unscrew.
2. If adjusting the handlebars, have your assistant
support the weight of the handbars from beneath.
3. Pull the pin outward and have raise or lower
the post.
4. Release the pin so it locks into the post at the
desired height, and tighten the knob to secure it
in place.
Содержание MYX II
Страница 1: ...1 Product Manual ...