17
Caring for Your MYX
MAINTENANCE
Preventative maintenance can extend the life of
your product and significantly reduce equipment
failures. The chart provided is our recommended
maintenance schedule. It is your responsibility to
ensure that regular maintenance is performed.
CLE ANING
We recommend wiping down and cleaning the
product frame daily. For a deeper clean use water
with a non-abrasive soap, car wash soap, or bike
cleaner. Wipe with water and dry. Avoid spraying any
liquids directly onto the product. Instead, spray onto
a clean towel first then wipe the product. You may
also seal the frame with wax or bike polish.
CHECKLIST
Inspect for loose nuts or bolts on
handlebar and seat assembly and
tighten as necessary.
Verify that pedal bolts connecting
pedals to bike crank are tight after the
first 10 hours of use and every 100 hours
of use thereafter. Tighten (clockwise)
with a 15mm box wrench.
Inspect pedals for excessive wobble or
side-to-side movement. If loose, they
need to be replaced.
Check flywheel alignment. Realign
flywheel nuts as necessary.
Tighten seat hardware (bolt connecting
seat to post)
Lubricate horizontal and vertical sliders
(for seat and handlebars) with dry film
lubricant with PTFE or wet film lubricant
with PTFE. Apply a layer and use a cloth
to clean up excess.
Inspect welds for any signs of cracking
Inspect leveling feet
Check for rust and remove any minor
buildup found using a small brush.
Inspect the seat for wear and tear. Rips,
tears, or excessive movement indicate
the seat needs to be replaced.
Inspect pedal toe clips and straps
for any looseness or excessive
wear. Replace if toe clips cannot
be tightened to pedal or if the strap
shows excessive wear.
Worn or damaged parts must be
replaced immediately, and should not be used
until the repair is made.
WEEKLY
MONTHLY
Содержание MYX II
Страница 1: ...1 Product Manual ...